Wont Start -- 2009 1.6 zetec tdci Wont Start -- 2009 1.6 zetec tdci. By Risengrave, April 12, 2016 in Ford Focus ST-Line mk4 Front Camera retrofit. Turn On the car (do not start it, just turn key on) shift gear to N then turn off the car and wait for 15 seconds. Shift gear to P turn on the car (do not start just turn key on) wait for 15 seconds then turn off key and turn on again, shift gear to N the car will give you message Transmission Ready. 6. Name: chris. Ford Model: focus 1.6 econwtic. Ford Year: 2009. UK/Ireland Location: Devon. Posted December 8, 2020. Hi, My focus wont start, turns over ok but does not start, I had greenflag out and there were no faults to be read from the OBD. He Injected fluid into the air intake and that did make it fire up momentarily. 06 1.6 tdci wont start after changing seals - 547HEW Cylinder 1 is at clutch end. Resistance of a piezo type injector (fitted to this engine) is in region of 200k ohm Mk2 cmax 1.6 tdci 8v same engine as mk3 focus. engine will not start when warm, changed cam and crank sensor, injectors, fuel rail sensor, clocks and pcm and all the relays and checked loom. There is no power going to the piezo injectors when its warm, would anyone know what controls injector pul They should all come on for a lamp test, then most go out except handbrake, oil, and maybe one or two others. There will be a diagnostic code available if the Engine warning message is on. Code readers are cheap (under £20) and easy to use, and the codes can sometime help. stevet125. My usually very reliable 2011 Mk2 Ford Focus 1.6 TDCI has let me down big time. It was running great then suddenly the engine malfunction warning came on, I managed to roll it to the edge of the road and it just wouldn't start. Whilst waiting for recovery the battery seemed to die with only hazards on, bought it home and recharged The car just cut out and now it won't start, won't even attempt to crank. Nothing when I turn the key. Ford Model: Focus 1.6tdci Ford Year: 1.6 TDCi Rough aIDKWY.